Aside from all the liabilities avoided by correcting potential trip.

Tree Roots, natural shifting or settling of ground, or concrete replacement where previous level was not matched can be the cause of a raised sidewalk or concrete pathway. Solution Concrete Grinding is a modern technique to eliminate trip and fall hazards. The process uses a Scarifier Concrete Grinder and Dry Surface Grinder different tree cutting notches sand down the raised side of two joining sections of concrete.

Concrete smoothness is also a problem, and though very important, receives less attention than other surface irregularities.

Mar 11, Concrete grinding or sidewalk cement grinding is one method to remove sidewalk trip hazards typically up to 1 1/2″ in height where sidewalks have been lifted by tree roots, shifting soil, etc. Concrete grinding will remove the top finished layer of cement and leave an exposed aggregate finish where the concrete trip area has been removed, but will also bring your sidewalk trip and fall hazard.

Get free shipping on qualified Concrete Grinders or Buy Online Pick Up in Store today in the Tools Department. Diamond grinding on roadways and other concrete structures is that it militates against hydroplaning by smaller vehicles. The grooved surface left after grinding provides a dual function.

The grooves enhance friction and facilitate channeling water away. Increased safety is the result, in addition to providing drivers with a smoother bushhaul.barted Reading Time: 3 mins. Stump grinding is much less intensive. In this case, arborists use a machine to completely shred the stump down into small woodchips.

Grinding is much more efficient than stump removal, however, it does leave the tree’s roots behind. If the stump is large, the chip pile produced can also be quite large, but the chips can be used as mulch for.

Diamond grinding levels the two surfaces, but it adds the advantages provided by friction, while also improving the surface.

1. Trace the High Spots (Above) Outline the space that needs to be ground. Using a level or other straightedge, find where the high spot meets the flat surface. Balance the straightedge on the high spot and mark where the ends of the level are equidistant from the ground and trace around the high spot.